FAQs | Find Answers

Search Results

Results 11 - 20 of 22

Recommended Links
  1. Some hard drives are not encrypted.(TS-2RZ series)
    [Answer ID: 15402]
    If you create a RAID 10 array with 12 drives and format it with encryption enabled, you will see the drive status shows drives 11 and 12 are not encrypted, but the RAID array is encrypted correctly....
  2. What does the message on the LCD display indicate when the ERROR LED is turned on? (TS3000 series)
    [Answer ID: 15469]
    Refer to the following boxes which is listed the meaning of LED blinking and the resolution.LCD MessageDescriptionCorrective ActionBOOT FAILHard drive not found.Contact Buffalo technical support for assistance....
  3. What does the message on the LCD display indicate when the INFO LED is turned on? (TS3000 series)
    [Answer ID: 15471]
    After you change settings or format a hard drive, the current status is displayed on the LCD.LCD MessageDescriptionCorrective ActionHDx Warning I11 Bad SectorsThe bad sectors in hard drive X may have reached a dangerous level....
  4. What does the message on the LCD display indicate when the ERROR LED is turned on? _02 (TS3000 series)
    [Answer ID: 15472]
    Refer to the following boxes which is listed the meaning of LED blinking and the resolution.If the firmware version is 1.12 or earlier, please click here to see the error codes.LCD Message...
  5. What does the message on the LCD display indicate when the INFO LED is turned on? _02 (TS3000 series)
    [Answer ID: 15473]
    After you change settings or format a hard drive, the current status is displayed on the LCD.If the firmware version is 1.12 or earlier, please click here to see the current status....
  6. Settings were reset after updating the firmware. (TS-2RZ Series)
    [Answer ID: 15633]
    Some settings will be reset after updating the firmware ver.1.xx to ver.2.00 or later. In this case, please set them again. Case 1. DLNA settings of a folder will be disabled.Solution 1....
  7. Only information for a guest user is displayed although I log in as an administrator or a member of the power users group.
    [Answer ID: 15397]
    There are cases where the privileges are reset after rebooting the TeraStation if you set privileges of an administrator or a member of the power users group on each group.In this case, log in with the administrator account and set the privileges again....
  8. When restoring the settings, the "rebooting" dialog opens.
    [Answer ID: 15398]
    Restoring is working without any problem even if the "rebooting" dialog opens.A "complete" message will be displayed when restoring is completed.
  9. The spare disk remains displayed after recovering the RAID array from spare disks.
    [Answer ID: 15400]
    There are cases where the spare disk remains displayed when you have recovered the RAID array from spare disks.The display will be corrected by rebooting the TeraStation.
  10. How to confirm WINS Server IP Address
    [Answer ID: 15593]
    WINS Server IP Address is not displayed in Workgroup Settings. Refer to the following steps to confirm WINS Server IP Address. In Settings, Click Network. Click  to the right of "Workgroup/Domain"....
< Previous  1  2  3  Next >

Refine your search

Select Product / OS & Hardware

      Enter Keywords or a specified ID