FAQs | Find Answers
Search Results
Results 101 - 110 of 110
Recommended Links
- TeraStation 4000 - How to replace a hard drive and rebuild a RAID array in the TeraStation?
[Answer ID: 15202]
Hard drives in the TeraStation show a blue status LED during normal operation. When a drive fails, its error LED will glow red. 1. Error LED Glows red if a hard drive has failed. 2. Status LEDs ...
- Active Directory - Invalid Characters for Password
[Answer ID: 15205]
When joining Active Directory with the LinkStation or TeraStation, the set of valid characters for password is limited to characters in ASCII table (alphanumeric) characters except for the following characters as well as blank (white) space:...
- TS4000 (enclosure) - Setting up the TeraStation
[Answer ID: 15206]
Hard drives are not included with TeraStation 4000 series. Before use, obtain hard drives and install them in the TeraStation. Firmware for installation is included on a USB recovery device....
- I cannot copy a file to the folder restricted by the OS after installing TurboPCEX.
[Answer ID: 15213]
Drag a file or a folder by right-clicking and choose "Copy here" or "Move here".You can now copy and move a file or a folder. - A Note about Wake on LAN（WOL）
[Answer ID: 15300]
When Wake on LAN(WOL) is enabled, the Email Notification function doesn't work even if you turn off the TeraStation. - Only information for a guest user is displayed although I log in as an administrator or a member of the power users group.
[Answer ID: 15397]
There are cases where the privileges are reset after rebooting the TeraStation if you set privileges of an administrator or a member of the power users group on each group.In this case, log in with the administrator account and set the privileges again....
- When restoring the settings, the "rebooting" dialog opens.
[Answer ID: 15398]
Restoring is working without any problem even if the "rebooting" dialog opens.A "complete" message will be displayed when restoring is completed. - The spare disk remains displayed after recovering the RAID array from spare disks.
[Answer ID: 15400]
There are cases where the spare disk remains displayed when you have recovered the RAID array from spare disks.The display will be corrected by rebooting the TeraStation. - A media cartridge is not recognized.（TS-2RZ series）
[Answer ID: 15401]
If you remove a media cartridge improperly, the status is not displayed correctly.The display will be corrected by rebooting the TeraStation. - Some hard drives are not encrypted.（TS-2RZ series）
[Answer ID: 15402]
If you create a RAID 10 array with 12 drives and format it with encryption enabled, you will see the drive status shows drives 11 and 12 are not encrypted, but the RAID array is encrypted correctly....